Product Description
Ameripolish® 3D SP E™ is a cutting-edge, breathable stain protector designed for superior surface protection. This semi-penetrating/semi-topical sealer provides a robust defense against stains and etching while enhancing the color of polished concrete floors. The enhanced formula of 3D SP E™ builds upon the success of its predecessor, offering improved abrasion and chemical resistance without sacrificing the ease of application.
Key Features:
- Advanced Protection: Shields polished and dyed concrete surfaces from both oil and water-based stains, as well as acidic etching agents.
- Color Preservation: Integrates seamlessly with other Ameripolish® products to safeguard and maintain the vibrancy of color in your slab.
- Ready to Use: No mixing required—apply directly from the container.
- UV Stabilizers: Helps prevent fading and preserves the appearance of the surface over time.
- Water-Resistant Barrier: Creates a protective layer that prevents liquid infiltration, reducing the risk of staining and etching.
- Low Odor & Safe: Non-flammable and compliant with VOC regulations (<5g/L), ensuring a safer working environment.
- Enhanced Formula: Offers advanced resistance to chemicals and abrasion for long-lasting protection.
Ideal Uses:
- Perfect for new or existing polished concrete floors.
Coverage & Application:
- Coverage: Approximately 2000-2500 sq. ft. per gallon (49-61 m²/L), depending on concrete porosity.
- Application Method: Apply using a low-pressure sprayer and Ameripolish® Microfiber Pad. For optimal results, apply two light coats, allowing the product to dry to a tack-free state between applications. Finish with high-speed burnishing using a 3000 grit or higher pad.
Preparation & Application:
- Surface Preparation: Complete all necessary grinding, coloring, and polishing. Ensure the surface is clean, dry, and free of contaminants. New concrete should cure for 28 days.
- Testing: Perform a test application on a sample area to ensure compatibility.
- Project Conditions: Ideal application temperature is between 40-90°F (4-32°C).
- Final Steps: Allow the floor to cure fully over seven days. For high-traffic or spill-prone areas, a third application may be beneficial.
Cleanup & Storage:
- Cleanup: Immediately clean tools and equipment with water.
- Storage: Store upright in a safe, dry place between 40-110°F (4-43°C). Keep from freezing and out of reach of children.
Compliance:
- Meets VOC regulations set by the US Environmental Protection Agency, California Air Resources Board, and other regional standards.
